Microstructure, kinetic analysis and hardness of Sn-Ag-Cu-1 wt% nano-ZrO2 composite solder on OSP-Cu pads

Nano-sized, nonreacting, noncoarsening ZrO₂ particle-reinforced Sn-Ag-Cu composite solders were prepared by mechanically dispersing ZrO ₂ nano-particles into Sn-Ag-Cu solder and the interfacial morphology between the solder and organic solderability preservative (OSP)-Cu pads were characterized metallographically. At their interfaces, island-shaped Cu ₆Sn₅ and Cu₃Sn intermetallic compound (IMC) layers were found in solder joints with and without the ZrO₂ particles and the IMC layer thickness was substantially increased with reaction time and temperature. In the solder ball region, needle-shaped Ag₃Sn and spherically-shaped Cu₆Sn₅ IMC particles were found to be uniformly distributed in the β-Sn matrix. However, after the addition of ZrO₂ nano-particles, Ag₃Sn and Cu₆Sn ₅ IMC particles appeared with a fine microstructure and retarded the growth rate of the IMC layers at their interfaces. From a kinetic analysis, the calculated activation energies for the total (Cu₆Sn₅ + Cu₃Sn) IMC layers for Sn-Ag-Cu and Sn-Ag-Cu-1 wt% ZrO₂ composite solder joints on OSP-Cu pads were about 53.2 and 59.5 kJ/mol, respectively. In addition, solder joints containing ZrO₂ nano-particles displayed higher hardness due to the uniform distribution of ZrO₂ nano-particles as well as the refined IMC particles. The hardness values of the plain Sn-Ag-Cu solder joint and solder joints containing 1 wt% of ZrO₂ nano-particles after 5 min reaction at 250 °C were about 15.0 Hv and 17.1 Hv, respectively. On the other hand, their hardness values after 30 min reaction were about 13.7 Hv and 15.5 Hv, respectively. © 2010 Elsevier B.V. All rights reserved.