Skip to main navigation Skip to search Skip to main content

In situ toughened silicon carbide with Al-B-C additions

  • Joe J. Cao
  • , Warren J. MoberlyChan
  • , Lutgard C. De Jonghe
  • , Christopher J. Gilbert
  • , Robert O. Ritchie

Research output: Journal Publications and Reviews › RGC 21 - Publication in refereed journal › peer-review

Abstract

"In situ toughened" silicon carbides, containing Al, B, and C additives, were prepared by hot pressing. Densification, phase transformations, and microstructural development were described. The microstructures, secondary phases, and grain boundaries were characterized using a range of analytical techniques including TEM, SEM, AES, and XRD. The modulus of rupture was determined from four-point bend tests, while the fracture toughness was derived either from bend tests of beam-shaped samples with a controlled surface flaw, or from standard disk-shaped compact-tension specimens precracked in cyclic fatigue. The R-curve behavior of an in situ toughened SiC was also examined. A steady-state toughness over 9 MPa·m1/2 was recorded for the silicon carbide prepared with minimal additives under optimum processing conditions. This increase in fracture toughness, more than a factor of three compared to that of a commercial SiC, was achieved while maintaining a bend strength of 650 MPa. The mechanical properties were found to be related to a microstructure in which platelike grain development had been promoted and where crack bridging by intact grains was a principal source of toughening. References.
Original languageEnglish
Pages (from-to)461-469
JournalJournal of the American Ceramic Society
Volume79
Issue number2
Online publishedFeb 1996
DOIs
Publication statusPublished - Feb 1996
Externally publishedYes

Fingerprint

Dive into the research topics of 'In situ toughened silicon carbide with Al-B-C additions'. Together they form a unique fingerprint.

Cite this