AI-Li/SiCp composites and Ti-AI alloy powders and coatings prepared by a plasma spray atomization (PSA) technique

There has been increasing use of Al-Li alloys in the aerospace industry, due mainly to the low density and high elastic modulus of this material. However, the problem of low ductility and fracture toughness of this material has limited its present application to only weight- and stiffness-critical components. Development of Al-Li/ceramic composites is currently being investigated to enhance the service capabilities of this material. The Ti-Al alloy is also of interest to aerospace-type applications, engine components in particular, due to its attractive high-temperature properties. Preparation of fine powders by plasma melting of composite feedstock and coatings formed by plasma spraying was carried out to examine the effect of spray parameters on the microstructure and properties of these materials. Characterization of the powders and coatings was performed using the scanning electron microscope and image analyzer. Examination of the plasma-sprayed powders and coatings has shown that in the Al-Li/SiC composite there is melting of both materials to form a single composite particle. The SiC reinforcement was in the submicron range and contributed to additional strengthening of the composite body, which was formed by a cold isostatic press and consolidated by hot extrusion or hot forging processes. The plasma-sprayed Ti-Al powder showed four categories of microstructures: featureless, dendritic, cellular, and martensite-like. © 1994 ASM International.